LBL Lighting Veneto - Manual (Page 3)

3
Install the Glass Shade
Place a plastic washer onto the cap screw.
From outside of the glass shade, insert the cap screw through
one glass shade hole.
Place the second plastic washer onto the cap screw and finger
tighten the knurled nut to secure the cap screw in place.
Repeat steps 2 through 5 for the remaining glass shade holes.
KNURLED NUT
PLASTIC WASHER
PLASTIC WASHER
GLASS SHADE
CAP SCREW
HOOK
Screw the three hooks completely to end of the three cap
screws. Make sure the hooks are facing down.
Skip to section 3D to install the glass. If the clips do not reach
the glass with the lamps installed, follow the steps in section
3C to install the hook extensions.
Screw the female end of the three hook extensions onto the
three cap screws.
Screw the male end of the three hook extensions onto the
three hooks.
HOOK
HOOK EXTENSION
3A 3B
3C
1
2
3
4
5
6
7
8
2
1
4 3
6
7
8