LBL Lighting Alban W LED - Manual (Page 2)

2
4
3
Install the Fixture
Connect the mounting plate ground wire to a suitable
ground according to local electrical codes.
Connect the brown (black) driver wire to the hot power
line wire with a wire nut.
Connect the blue (white) driver wire to the neutral
power line wire with a wire nut.
Properly place the driver, all wires, and wire nut
connections into the fixture base.
Mount the fixture by sliding it back onto the mounting
plate and reinstalling the fixture screws (reversal of
figure 1A).
1
2
3
2A
2
1
5
DRIVER
SAVE THESE INSTRUCTIONS!
© 2014 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
A Generation Brands Company
Remove the two Allen screws located on the rear of the
end caps with the Allen wrench provided.
Remove the two end caps.
Carefully slide the shade into the fixture base brackets.
Reinstall the end caps and Allen screws to secure the
shade in place.
3A
1
2
3
SHADE
END CAP
ALLEN
WRENCH
ALLEN
SCREW
FIXTURE
BASE
FIXTURE
BRACKET
1
Install the Shade
3
4