LBL Lighting Zanz 3-Light - Manual (Page 3)

3
Push the new lamp firmly all the way into the socket.
Repeat for all the sockets.
NOTE: Use only your fingers to replace the lamp.
Use Volt, type T4, G9 base
MAX 60 120 Watt
bi-pin halogen lamp.
Install the Lamp
1
4A 1
SOCKET
LAMP
Install the Fixture
Connect the fixture to a suitable ground in accordance
with local electrical codes.
Connect the white fixture wire to the neutral power line
wire with a wire nut.
Connect the black fixture wire to the hot power line
wire with a wire nut.
Place all wires and wire nut connections in the electrical
box and mount the fixture by sliding it back onto the
mounting plate and reinstalling the two screws (reversal
of figure 1A).
3A
1
2
3
4
1
2
3
NOTE: To replace lamp, reverse section 4.
2