Aiphone JB-DVF-HID-I - Manual (Page 2)

Master
JB-2M(E)D
JB-DVF-HID-I
PS-1820UL
+
-
+
-
1A1
1A2
B1
B2
2A1
2A2
S
S
A1
A2
Output to Host
Access Control System
WIRING DIAGRAM:
TESTING AND OPERATION:
SPECIFICATIONS:
Aiphone Communication Systems
1700 130th Ave. N.E.
Bellevue, WA 98005
(425) 455-0510
FAX (425) 455-0071
TOLL FREE TECHNICAL SUPPORT: (800) 692-0200
TOLL FREE FAX LINE: (800) 832-3765
E-MAIL: [email protected]
Page 2
JB-DVF-HID-I Instr.
0706JDJS
FCC WARNING:
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference that may cause undesired operation.
For proper regulatory compliance, the drain wire should be disconnected at the
power supply end of the cable.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
The Reader is intended to be powered from a limited power source output of a
previously certified power supply.
When power is applied to the
iClass
reader, the LED will turn RED while the beeper beeps
simultaneously 3 times. (The last tone is a higher frequency). The LED will then flash once after the
last tone. This indicates that the microcontroller is operating properly.
Present an
iClass
ID card to the reader (Hold the card directly in front of reader). The LED will
momentarily turn green while the beeper beeps once, indicating that the card was read successfully.
CARD READER:
Power Source:
10 ~ 16 VDC / 65 ~ 225mA
Current Requirements: 80mA (Avg); 300mA (peak) at 12V
Transmit Frequency:
13.56 MHz
Terminations: Color-coded pre-wired pigtails
Wiring Distance: 500'
Operating Temperature: -10° ~ 60° C / 14° ~ 140° F
Operating Humidity:
5% to 95% relative humidity
non-condensing
CAMERA:
Camera unit:
CCD Camera
Scanning line: 525 lines
Min. illumination: 1 Lux or less at 1'
Terminations: Screw terminals
Wiring Distance: 330' w/871802 wire
980' w/JBW-BA & 851602 wire
Dimensions (camera): 5-¾” W x 11-⅝” H x 1-5/16" D
With SBX-DVF-P:
5-15/16" W x 11-¾” H x 2-13/16" D (Top)
1-15/16" D (Bottom)