LBL Lighting Linea - Manual (Page 2)

1E
2
Push the anchors into the marked points on the wall up to the
threaded portion.
Screw the anchors in the rest of the way with a Phillips
screwdriver.
ANCHOR
MARKED POINT
Feed the power line wires through the round plate center hole,
backplate center hole, lock washer, washer, and nipple.
Slide the round plate and backplate onto the nipple attached to
the crossbar. Level the backplate horizontally and line up the
end holes with the anchors.
Tighten the nut to secure the round plate and backplate in
place.
ANCHOR
END HOLE
BACKPLATE
ROUND PLATE
LOCK WASHER
WASHER
NUT
SOCKET HOUSING
Connect the black fixture wire to the hot power line wire with
a wire nut.
Connect the white fixture wire to the neutral power line wire
with a wire nut.
SOCKET HOUSING
Place all wires and wire nut connections into the socket
housing.
Push the two #8 screws through the screw hole next to the
each socket.Tighten the screws to the anchors through the
end holes in backplate.
END HOLE
SOCKET
#8 SCREW
BACK PLATE
SOCKET
LAMP CONTACT
Use 120 Volt, Watt Type Linestra Incandescent MAX 60
Single Contact Double S14S Base Lamp With Model
LN60SI.
Use 120 Volt, Watt Type Linestra Incandescent MAX 150
Single Contact Double S14S Base Lamp With Model
LN120SI.
Turn off power to the fixture.
Push the lamp so the contacts snap into the sockets.
Turn the power to the fixture on.
SWITCH
Install the Lamp
1D
9
10
11
12
13
1F
14
15
10
12
13
9
11
12
15 16
1
2
3
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
2A
1G
16
17
16
17 17
2
1
2