LBL Lighting Modular New York Medium/Large T8 with Emergency Backup - Manual (Page 3)

3
Install the Lamps
Connect the neutral power line wire to the white fixture wire
marked “COM” with a wire nut.
Connect the hot power line wire to the black switched
fixture wire marked “SWITCHED HOT” with a wire nut.
Connect the hot power line wire to the black unswitched
fixture wire marked “ALWAYS HOT” with a wire nut.
Connect the red test switch wire to the loose red fixture wire
with a wire nut. Connect the white test switch wire to the
loose red/white fixture wire with a wire nut.
Plug the white/black unit connector wires together.
CAUTION: RISK OF SHOCK! Plug these wires in only
after all other connections have been made.
Reinstall the reflector into the housing and tighten all six
screws to hold it in place. Place the reflector so the end
marked “THIS SIDE UP” is at the top.
Medium MAX 17 Watt versions use type T8 linear
fluorescent lamp.
versions use type T8 linear Large MAX 25 Watt
fluorescent lamp.
Line up the lamp pins on both ends with the opening on the
sockets.
Insert the pins all the way into the sockets and turn the lamp
to lock it in place.
Reinstall the front cover on to the housing and fully tighten all
six cap screws. Tighten all the cap screws evenly to prevent
the cover from flexing, which could cause the glass to break.
1G
14
15
2A
16
1
2
3
19
19
19
2 2
2 2
16
15
19
19
17
14
18
17
18
19