Save these instructions, 1d 1a 1e, 1f 1a 1g – LBL Lighting 2-Circuit MO Adjustable Cable Standoff User Manual
Page 2
2
Screw the cable post completely to the threaded nipple.
CABLE POST
THREADED NIPPLE
Feed the aircraft cable through the cable grip tab by pushing
the cable grip tab down.
Pull the aircraft cable out through the side hole on the post.
Adjust the standoff height by moving the standoff up or down.
Repeat steps 8 through 10 for the remaining standoffs.
AIRCRAFT CABLE
CABLE GRIP TAB
Remove the housing cap on all standoffs.
HOUSING CAP
Place a section of the 2-Circuit Monorail into standoff
housings.
While supporting the 2-Circuit Monorail, tighten the housing
cap completely to the standoff housings to secure the
2-Circuit Monorail in place.
Repeat steps 13 and 14 for the remaining 2 standoffs.
If necessary, readjust the standoff height by repeating steps 9
and 10.
After achieving the desired standoffs height, trim off excess
aircraft cable coming out of the cable grip posts.
NOTE:
In case of cross threading, loosen the cap and
repeat step 14.
STANDOFF HOUSING
2-CIRCUIT MONORAIL
HOUSING CAP
AIRCRAFT CABLE
1A
8
9
1D
1A
1E
8
9
10
10
11
1A
12
13
1F
1A
1G
12
17
14
15
16
17
13
14
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
SAVE THESE INSTRUCTIONS!
A Generation Brands Company