Save these instructions, Install the 2-circuit monorail to standoffs, 1a 1d – LBL Lighting 2-Circuit MO Direct Feed Standoff for Canopy User Manual
Page 2: 1a 2a 1a 2b
Screw the standoff support post completely to the threaded
nipple.
Repeat this step for the remaining standoffs.
SUPPORT POST
THREADED NIPPLE
Install the 2-Circuit Monorail to Standoffs
Remove the housing cap on all standoffs.
HOUSING CAP
Place a section of the 2-Circuit Monorail into standoff
housings.
While supporting the 2-Circuit Monorail, tighten the housing
cap completely to the standoff housings to secure the
2-Circuit Monorail in place.
Repeat steps 2 and 3 for the remaining standoffs.
NOTE:
In case of cross threading, loosen the cap and
repeat step 3.
STANDOFF HOUSING
2-CIRCUIT MONORAIL
HOUSING CAP
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
SAVE THESE INSTRUCTIONS!
A Generation Brands Company
1A
1D
8
9
1
8
2
2
1
2
3
4
1A
2A
1A
2B
3