LBL Lighting 2-Circuit MO 4" Round Canopy Dual Feed - Manual (Page 2)

1
2
Properly place the all the wires and wire nut connections
into the electrical box.
Mount the canopy to the electrical box/mounting plate
with two #8-32 screws provided.
8 12
8 13
1C
#8-32
SCREW
Connecting the Center Power Feeds
13
13
SCREW
POWER FEED CAP
POWER FEED
HOUSING
MIDDLE
CONTACT
Remove the power feed cap from the power feed housing.
Completely back out the screw on the power feed cap.
Loosen (Do Not Remove) the set screw and knurled cap on
the power feed housing, and pull the middle contact wire
slightly out so that the middle contact is not exposed.
2B
4
5
3
3
4
5
POWER FEED CAP
2-CIRCUIT MONORAIL
POWER FEED
HOUSING
Place one power feed housing onto one electrically isolated
Two-Circuit MonoRail sections.
Screw the power feed cap completely to the power feed
housing. Make sure that the power feed cap is not cross
threaded.
POWER FEED CAP
SCREW
KNURLED CAP
HOT 1
HOT 2
COM
Tighten the screw on the power feed cap for proper power
connection.
Tighten the knurled cap for proper power connection, and
tighten the set screw near the knurled cap.
Repeat steps 1 through 7 to connect the other power feed
housing an electrically isolated section of Two-Circuit
MonoRail.
2C
7
2D
6
7
9
8
2A
1/16 ALLEN WRENCH #6-32 SET SCREW
THREE PIN INSULATED CONNECTOR
TWO-CIRCUIT MONORAIL TWO-CIRCUIT MONORAIL
Insert the three pin insulated connector into each end of
the Two-Circuit MonoRail.
Tighten the three #6-32 set screws on the three pin
insulated connector with the 1/16 Allen wrench
provided.
NOTE: To avoid stripping the three pin insulated
connector, do not over tighten the #6-32 set screws.
8
9
CAUTION: Ensure that the power feed connections
are on sections of Two-Circuit MonoRail that are
isolated from each other.
10
1
2
8 1
8 2
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting. All rights reserved. The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
SAVE THESE INSTRUCTIONS!
A Generation Brands Company
6
7