Adjust the standoff height, 1a 1d, 1a 1e 1a 1f – LBL Lighting 2-Circuit MO Direct Feed Standoff for Surf Xfmr User Manual
Page 2: 1a 2a
Push the standoff rod completely into the support post and
tighten the M4 set screw with the 2 MM Allen wrench.
Repeat steps 8 through 10 for the remaining standoffs.
2
Loosen
the M4 set screw on the support
(Do Not Remove)
post with the provided 2 MM Allen wrench and remove the
support post.
SUPPORT POST
2 MM ALLEN
WRENCH
M4 SET
SCREW
Screw the support post completely to the threaded nipple.
SUPPORT POST
THREADED NIPPLE
SUPPORT POST
STANDOFF ROD
2 MM ALLEN
WRENCH
M4 SET SCREW
Adjust the Standoff Height
Slightly loosen
the M3 set screw on the
(Do Not Remove)
side of the telescoping post with th 1.5 MM Allen wrench
provided.
Adjust standoff height to match the surface mount transformer
height and tighten the M3 set screw with 1.5 MM Allen
wrench.
Repeat steps 1 and 2 for remaining standoffs.
M3 SET
SCREW
1.5MM ALLEN
WRENCH
TELESCOPING POST
1A
1D
8
9
8
1A
1E
1A
1F
9
10
10
11
1
2
3
1A
2A