Connect the 2-circuit monorail to the transformer, 1a 2a 1a 2b, 1a 2c – LBL Lighting 2-Circuit MO Direct Feed Surf Xfmr Mag 500w 120v/12v User Manual

Page 3

Advertising
background image

3

Connect the 2-Circuit Monorail to
the Transformer

Tighten the screw on the power feed cap for proper power

connection.

Tighten the knurled cap for proper power connection.

SCREW

Remove the power feed cap from the power feed housing.

Completely back out the screw on the power feed cap.

Loosen

the knurled cap on the power

(Do Not Remove)

feed housing and pull the center wire slightly out so that the

middle contact is not exposed in power feed housing.

NOTE:

The standoffs should be installed to support the

2-Circuit Monorail while connecting 2-Circuit Monorail to
the surface mount transformer. Refer to the instructions
provided with the standoffs.

POWER FEED CAP

KNURLED CAP

CENTER WIRE

POWER FEED HOUSING

MIDDLE
CONTACT

Place a 2-Circuit Monorail section into the standoffs and

power feed housings.

Screw the power feed cap completely to the power feed

housing. Make sure that the power feed cap is not cross
threaded.

POWER FEED CAP

2-CIRCUIT MONORAIL

POWER FEED HOUSING

POWER FEED CAP

SCREW

KNURELD CAP

1A

2A

1A

2B

1

2

1

3

3

3

2

4

6

5

7

1A

2C

4

5

7

6

Advertising