LBL Lighting Fusion Jack Canopy 4" Square Flush Wood LED - Manual (Page 2)

1E 1H
1F
1G
1I
2
Secure the mounting plate to the anchors with the provided
#8 screws.
#8 SCREW
Insert one end of the safety cable into the mounting plate
safety bracket and insert the other end into the housing safety
bracket.
FUSION
JACK PORT
FIXTURE
FUSION
JACK
Screw each fixture Fusion Jack completely into the Fusion Jack
port.
Turn the power on.
SAVE THESE INSTRUCTIONS!
Connect the housing green wire to the mounting plate ground
wire with a wire nut.
Connect the housing white wire to the neutral power line wire
with a wire nut.
Connect the housing black wire to the hot power line wire
with a wire nut.
Place all wires and wire nut connections properly inside
the housing.
CAUTION: load per RISK OF FIRE. Maximum
port is watt. 60 Do Not Overload!
Slide the housing onto the mounting plate and line up the
housing holes with the mounting plate holes.
Replace and tighten the four #8-32 screws to secure the
housing in place.
SAFETY
CABLE
SAFETY
BRACKET
SAFETY
BRACKET
#8-32 SCREW
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2008 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
15
10
11
12
14
13
15
14
14
17
16
9
18
9
9
9
9
10
10
11
12
13
17
16
16
16