Connect the monorails to transformer – LBL Lighting MO Direct Feed Surf Mag Xfmr 600w 120v/12v User Manual
Page 3
3
Connect the Monorails to Transformer
Push two Monorail sections completely onto the straight
isolating connectors.
Tighten the M3 set screws firmly with the provided 1.5 MM
Allen wrench.
the set screws which
Do Not Over Tighten
may strip the thread.
M3 SET SCREW
1.5 MM ALLEN
WRENCH
MONORAIL
MONORAIL
STRAIGHT ISOLATING CONNECTOR
POWER FEED
HOUSING
POWER
FEED CAP
SCREW
Remove the power feed caps from the power feed housings.
Completely back out the screw on the power feed caps.
NOTE:
The standoffs should be installed to support the
Monorails while connecting Monorails to the surface
mount transformer. Refer to the instruction provided with
the standoffs.
MONORAIL
POWER
FEED CAP
Place the combined Monorail sections into the standoffs and
power feed housings so that the straight isolating connector
section is located in the middle of the two power feed
housings. Make sure that the Monorail sections are
electrically isolated from each other.
Screw the power feed caps completely to the power feed
housings. Make sure that the power feed caps are not cross
threaded.
Tighten the screw on the power feed caps for proper power
connection.
SCREW
MONORAIL
STRAIGHT ISOLATING CONNECTOR
NOTE:
It is recommended that two people install the
Monorail sections to the standoff and power feed
housings.
1A
2A
1A
2C
1A
2B
1
4
5
2
2
3
3
4
5
6
7
6
7