Install the canopy, 2a 2c 2d – LBL Lighting MO Flush Elec Xfmr 60w 277v/12v LED User Manual
Page 2
2
Cut the center power feed wires to the desired length.
With a sharp knife cut 1" from the end of the wire web
and separate the wires 8" from each other.
Push the power feed wires through the canopy bushings
and slide the canopy down the wires.
Strip 1/2" off the wire ends.
Properly place the transformer, wires, and wire nut
connections into the electrical box.
Slide the canopy up and secure it to the electrical box by
screwing the cap with nipple to the crossbar.
CAP WITH NIPPLE
Push the excess power feed wires into the canopy and
tighten the plastic screw with the provided Allen
wrench.
PLASTIC SCREW
ALLEN
WRENCH
2A
2C
2D
4
5
6
8
10
3
8
9
BUSHING
5
Install the Canopy
2B
7
TRANSFORMER
8
8
9
10
BUSHING
5
Ground the mounting plate in accordance with local
electrical codes.
Connect the red driver wires to the power feed wires.
Connect the white driver wire to the neutral power line
wire.
Connect the black driver wire to the hot power line
wire.
7
8
6
9
6
10
8
8
9