LBL Lighting MO Surf Elec Xfmr 150w 120v/12v - Manual (Page 2)

2
CROSSBAR
#8-32 FLAT
HEAD SCREW
Remove the two #8-32 flat head screws to remove the
crossbar.
#8-32
SCREW
CROSSBAR
Mount the crossbar to the electrical box with the provided
two #8-32 screws.
Install the Mounting Plate
1A
1
1 1
1B
2
2
2
2A
Adjust the Height
STRAIN RELIEF
POWER FEED WIRES
TRANSFORMER
HOUSING
SET SCREW
1
2
6 3
6 4
Take note of the wire connections and remove the wire
nuts to disconnect the power feed wires from the transformer
output wires.
Loosen the set screws on the strain relief and pull out
the power feed wires.
Cut the end power feed wires to the desired length.
With a sharp knife cut 1" from the end of the wire web
and separate the wires 8" from each other.
Push the power feed wires through the strain reliefs
leaving at least 6” of cord in the back of the transformer
housing for wire connections and tighten the set
screws.
Strip 1/2" off the wire ends and reconnect the power
feed wires to their original connections.
6 5
6 6