LBL Lighting MO Bracket - Manual (Page 2)

2
SUPPORT POST
Loosen the M4 set screw on the support (Do Not Remove)
post with the 2 MM Allen wrench provided to remove the
support post.
2 MM ALLEN WRENCH
M4 SET SCREW
Screw the support post completely onto the threaded nipple.
SUPPORT POST
THREADED
NIPPLE
SUPPORT POST
STANDOFF ROD
2 MM ALLEN WRENCH
M4 SET SCREW
Push the standoff rod completely into the support post and
tighten the M4 set screw with the 2 MM Allen wrench.
Repeat steps 7 through 9 for the remaining standoffs.
Adjust the Standoff Height (Optional)
Slightly loosen the M3 set screw on the (Do Not Remove)
side of the telescoping post with th 1.5 MM Allen wrench
provided.
Adjust standoff height and tighten M3 set screw with 1.5 MM
Allen wrench.
Repeat steps 1 and 2 for the remaining standoffs.
M3 SET
SCREW
1.5MM ALLEN
WRENCH
TELESCOPING POST
Install the Cable Post
ANCHOR
WALL
Select a location on the wall above the support post to install
the cable post (the cable is recommended to be at a minimum
angle of 30 º to the support rod).
Tap the anchor at the marked point up to the threaded portion
with a hammer.
Screw the anchor in the rest of the way with a Phillips
screwdriver.
Insert the #8 screw into the threaded washer and tighten the
#8 screw completely into the anchor to secure the threaded
washer in place.
Repeat step 1 through 4 for the remaining standoffs.
ANCHOR
#8 SCREW
THREADED WASHER
1D
7
8
9
1E
10
1F
2A
3A
3B
1 1
2
3
1 1
2
3
4
5
7
8
9
1
2
1
3
4