iPazzPort KP-810-02 - Manual (Page 6)

Starting Wireless Handheld Keyboard and Mouse Touchpad
Starting up this hardware and application is simple.
1. Plug the USB adaptor into any available USB port.
2. Power on the Wireless Handheld Keyboard and Mouse Touchpad by
moving the slide switch as shown by arrow 8.
3. Wait 30 seconds. LED 3 will light up and then go out, this is normal.
When you touch the Mouse Touch Pad or press any keys LED 3 will flash
indicating proper operation of the unit and transmission between the USB
adaptor and the Wireless Handheld Keyboard and Mouse Touchpad . The
USB adaptor will also flash about every second.
A. If you find that LED 3 is blinking rapidly please check the following
two items:
1. Check your distance between the Keyboard and the computer.
Is it within 30’?
2. Check to see if you have plugged in the USB adaptor to your
computer correctly.
4. The Wireless Handheld Keyboard and Mouse Touchpad has a battery
saving feature. This feature puts the device into sleep mode if you do not use it
after 3 minutes. LED 3 will blink continuously. You can wake up the unit by
pressing any key for one second.
5. Arrow 10 points to the Input Switch Key
When this key is pressed LED 5 will light up. This LED will stay on until this key
is pressed again. That means while this light is on any key you press will use its
secondary input rather than its primary input. For example the key B is normally
B or b, but when you press the SF key it becomes the number 0. When you
have selected the Input Switch Key LED 5 will light up. When you are in normal
mode LED 5 will be turned off.