iPazzPort KP-810-02 - Manual (Page 8)

though you were using your mouse pad. Watch the mouse move to where
you want it, and then use the keyboard for whatever action you desire. You
can draw patterns using the TMP if you have installed MS Paint, ScreenPen
or other Paint software.
11. Rarely but possible if two or more Wireless Handheld Keyboard and
Mouse Touchpad are within a close proximity the units may get confused.
In that situation you need to run an ID Code Verification procedure. This is
very simple process. Please unplug all the Wireless Handheld Keyboard
and Mouse Touchpad USB Adaptors from their respective computers and
then power off all of the Wireless Handheld Keyboard and Mouse
Touchpad. Then take any pair which of Wireless Handheld Keyboard
and Mouse Touchpad and USB Adaptor to begin ID Code Verification
procedure. First turn on your Wireless Handheld Keyboard and Mouse
Touchpad and then re-insert the USB Adaptor into a vacant USB port. Now
simultaneously press the Left Mouse Button as indicated by arrow 12 above
and the RF key indicated by arrow 9 above until LED 3 begins to flash slowly.
Immediately release both keys. You should see LED 3 flash rapidly for
about 5 seconds. If you have observed this then you have successfully
completed ID Code Verification.
After completed ID Code Verification, use mouserate.exe to confirm the
Wireless Handheld Keyboard and Mouse Touchpad works fine. Move
TMP on Mouserate window, you read the average is about 70 or above, as
more as better. If it is below the value, please repeat to adjust.
After you have completed the ID Code Verification the Wireless Handheld
Keyboard and Mouse Touchpad will immediately enter power save mode.
In order to wake the unit, please press any key.
If you find that LED 3 are flashing slowly after your attempt at ID Code
Verification then it means you have not successfully completed the pairing of