Samlex America MSK-10A - Manual (Page 8)

8 | SAMLEX AMERICA INC.
SeCtIOn 3 | Installation
figure 3-1 Mounting & Cooling
Step 3: mark Holes
Use a pencil or pen to mark the four (4) mounting hole locations on the mounting
surface.
Step 4: Drill Holes
remove the controller and drill 4.5Mm holes in the marked locations.
Step 5: Secure Controller
Place the controller on the surface and align the mounting holes with the drilled holes
in step 4. Secure the controller in place using the mounting screws.
WiRinG
i
inFo
• A recommended connection sequence has been provided below for
maximum safety during installation.
• The controller is a common Positive ground controller.
!
cAUtion!
• Do NoT CoNNeCT loADS To THe loAD TeRmINAlS wITH SuRGe PoweR
exceeDinG 10A.
• foR mobIle APPlICATIoNS, be SuRe To SeCuRe All wIRING.
Warm Air
Cool Air
150 mm / 5.9"
150 mm / 5.9"