Samlex America DC-FA-300 - Manual (Page 2)

3 2
D. Slide the Insulating Cap onto the rectangular strip of the CFBAR and then insert the hood portion onto the
exposed portion of the stud of the CFBAR. See Figures 8 and 9.
Fig. 8. Insulating Cap slid over the rectangular portion of CFBAR Fig. 9. CFBAR with fitted fuse MRBF
E. Bolt the CFBAR to the Positive terminal stud of the Battery usually denoted by the ‘+’ sign as shown in Fig. 10.
Fig. 10. Installed arrangement
F. Please ensure that all the connections are tight.
Fig. 1. Marine Rated Battery Fuse (MRBF) Fig. 2. Clamping Fixture Bar (CFBAR) or
Single Pole Fuse Bar
Fig. 3. M-8 Nut, Flat Washer and Spring Washer Fig. 4. Insulating cap
INsTALLATION
A. Insert the fuse MRBF onto stud provided on the CFBAR. See Fig.5.
Fig. 5. Fuse MRBF inserted into the stud on CFBAR
B. Insert the cable lug (crimped to one end of the Positive battery cable) onto the CFBAR stud so that it sits
over the fuse MRBF. See Fig. 6.
Fig. 6. Fuse MRBF and cable lug inserted into the stud of the CFBAR
C. Insert the flat washer, the spring washer and the M-8 nut on to the CFBAR stud and tighten the nut with a
½” wrench. See Fig. 7.
Fig. 7. Fuse MRBF and Positive cable fixed to the CFBAR