Campbell Scientific 10164-L Water Sampler Control Cable for use with Isco and Sigma Autosamplers - Manual (Page 8)

10164-L Sampler Control Cable for use with Isco and Sigma Autosamplers
3. Wiring
3.1 General Wiring Information
FIGURE 3-1 shows a schematic of the 10164 and TABLE 3-1 shows pin
connector and wire functions.
Sections 3.2 through 3.4 provide information about connecting the wires to a
datalogger. The datalogger wiring depends on the function.
FIGURE 3-1. 10164 Sampler Control Cable Schematic
TABLE 3-1. Technical Details of Cable Design
Wire Color Via Connector Pin
Brown Direct D
Green Direct F
Purple Direct B
Yellow Solid State Relay Circuit None (controls C)
Red Solid State Relay Circuit C
Orange 20 kohm Resistor E
Clear Cable Shield No Connection
2