Campbell Scientific AL200 ALERT2 Encoder, Modulator, and Sensor Interface - Manual (Page 5)

Table of Contents
PDF viewers: These page numbers refer to the printed version of this document. Use the
PDF reader bookmarks tab for links to specific sections.
1. Introduction ................................................................. 1
2. Cautionary Statements ............................................... 1
3. Initial Inspection ......................................................... 1
4. Quickstart .................................................................... 2
4.1 Stand-Alone Mode ............................................................................... 2
4.1.1 Physical Setup ............................................................................... 2
4.1.2 Configuring the AL200 ................................................................. 2
4.2 Datalogger Peripheral Mode ................................................................ 3
4.2.1 Physical Setup ............................................................................... 3
4.2.2 Configuring the AL200 ................................................................. 3
5. Overview ...................................................................... 4
6. Specifications ............................................................. 5
7. Installation ................................................................... 8
7.1 Configuring the AL200 ........................................................................ 8
7.1.1 Stand-alone Device ....................................................................... 9
7.1.2 Datalogger Peripheral ................................................................. 12
7.2 Mounting in an Enclosure .................................................................. 14
7.3 Grounding .......................................................................................... 14
7.4 Wiring ................................................................................................ 14
8. Operation ................................................................... 14
9. Maintenance .............................................................. 15
10. Troubleshooting........................................................ 16
11. Repair ......................................................................... 16
Appendices
A.
Glossary .................................................................. A-1
B. Cables and Connector Pin Descriptions .............. B-1
B.1 CS I/O .............................................................................................. B-1
B.2 RS-232 ............................................................................................. B-1
i