Campbell Scientific CS475, CS476, and CS477 Radar Water Level Sensor - Manual (Page 7)

Table of Contents
B-4. SDI-12 transparent mode on CR10X datalogger using control
port 1 and changing SDI-12 address from 0 to 1 ........................B-10
B-5. SDI-12 transparent mode on CR10X-PB table-based datalogger
using control port 1 and changing SDI-12 address from 0 to 1 ..B-11
Tables
4-1. Default Settings....................................................................................2
4-2. Radiation Beam Spread for CS475 (10° Beam Angle) ........................3
4-3. Radiation Beam Spread for CS476/CS477 (8° Beam Angle) ..............3
4-4. Description of Polarization Markings Labels.......................................4
4-5. Example of a Start False Echo Learn Command..................................5
4-6. Example for Setting Water Stage .........................................................5
5-1. Description of Components and Hardware Labels.............................10
7-1. Wiring Diagram .................................................................................17
7-2. SDI-12 Command Codes ...................................................................18
8-1. Example of Start Measurement Command.........................................22
8-2. Acknowledge Active Command ........................................................22
8-3. Send Identification Command............................................................23
8-4. Checking CRC Example ....................................................................24
8-5. Description of Changing the Electronics Labels ................................27
A-1. Description of Instrument Housing Labels...................................... A-2
B-1. SDI-12 Commands...........................................................................B-2
B-2. SDI-12 Command for Querying the Address...................................B-3
B-3. Example of Setting Address.............................................................B-4
B-4. Example of Setting Units .................................................................B-4
B-5. Example for Setting Water Conditions ............................................B-5
B-6. Example for Setting Power Operation Mode ...................................B-6
iii