Campbell Scientific CSM1 Card Storage Module - Manual (Page 64)

Appendix A. PCMCIA Driver Software Notes
A-2
A.2.2 SystemSoft CardSoft Drivers
Socket Services 2.1 Version 1.00, Card Services 2.1 Version 2.05
The minimum required drivers for SMCRead are shown as follows as they
would appear in your CONFIG.SYS file (your PATH may differ ):
DEVICE=C:\PCMCIA\SSVADEM.EXE
DEVICE=C:\PCMCIA\CS.EXE
DEVICE=C:\PCMCIA\CSALLOC.EXE C:\PCMCIA\CSALLOC.INI
A.2.3 Ventura Micro CardWare Drivers
Socket Services Level 2.1 Release 1.01, Card Services Level 2.1 Release
1.00
The minimum required drivers for SMCRead are shown as follows as they
would appear in your CONFIG.SYS file (your PATH may differ ):
DEVICE=C:\PCMCIA\PCSS.EXE
DEVICE=C:\PCMCIA\PCCS.EXE
DEVICE=C:\PCMCIA\PCENABLE.EXE /F=C:\PCMCIA\CARDWARE.INI
A.2.4 Phoenix CardManager Drivers
Socket Services 2.1 Version 1.00, Card Services Release 2.1 Version 1.00
The minimum required drivers for SMCRead are shown as follows as they
would appear in your CONFIG.SYS file (your PATH may differ ):
DEVICE=C:\PCMCIA\CNFIGNAM.EXE /DEFAULT
DEVICE=C:\PCMCIA\PCMSS.EXE
DEVICE=C:\PCMCIA\PCMCS.EXE
REM the following line is not required, but recommended
DEVICE=C:\PCMCIA\PCMRMAN.SYS
A.3 Adjusting Your CardServices Set-up
CardServices has the ability to map a region of PCMCIA card to a region of
PC memory in the high-memory area. This is the same area of memory used
by programs loaded high with DEVICEHIGH or LOADHIGH. If all the high
memory is allocated then CardServices will not be able to map regions of
SRAM cards and SMCRead will fail with an error ‘lack of resources’. The
following information explains what to do if you have this problem.
Card Services does not use the actual memory in the high memory area, but it
does use that address space. The memory in that address space is never used.
If you have EMM386 loaded (which you will have if you load things into high
memory) you must exclude an area of memory for card service.