Campbell Scientific CSM1 Card Storage Module - Manual (Page 72)

Appendix C. SMCRead Error Messages
C-2
Error writing data to disk, collection aborted.
An unforeseen error has occurred when writing data to disk.
No data stored in the card!
The newest file does not contain any data!
Invalid location specified in command line parameter!
For the L option you have specified an invalid display location number in the
DOS command line.
Unable to move the display pointer to that location! -
check validity.
The value entered may be too large for the card size in use.
No data found in the area specified
Self explanatory - only displayed when using the L option.
No data stored in this area.
Displayed when collecting several files. This usually means a program file
was encountered between two data files.
No data found in the card!, or file error.
After attempting to collect several files, the program has not successfully
written any data to disk.
No uncollected data found in the card!
Error: no such command
While in the ‘Terminal Emulator’ you have typed an incorrect command.
The Card in the socket is write protected
The switch on the card is set to write protect. It should be set to the
unprotected position for operation with SMCRead.
Card Services Error Code xxxx - xxxxxxxxxxxxx
SMCRead has encountered an error when communicating with the card
services driver. There are many errors that could be reported, each detailing a
possible cause. Please contact Campbell Scientific if the solution is not
evident.