Campbell Scientific ID-2000W Software - Manual (Page 13)

SECTION 1. THE BASICS
1-3
FIGURE 1-3. FFT View
1.1 TOOLBAR BUTTONS
The ID-2000 toolbar is immediately below the menu at the top of the window and consists of buttons with
graphical icons on them. Clicking these buttons is a shortcut for various menu selections. The toolbar
uses “tool tips” which are little reminders that automatically pop up next to the mouse cursor if you move
the mouse over a toolbar button and leave it there for approximately one second. In addition to tool tips
the status bar at the bottom of the window also displays information about the function of each toolbar
button.
There are two sizes of toolbars from which you may select. The default is the large toolbar which is
used throughout this Help file. It looks like this:
The small toolbar is similar and looks like this:
You may select which toolbar you wish to use in the Preferences dialog box under the General tab. The
small toolbar button is primarily for VGA users that do not have enough screen resolution to display the
entire large toolbar. Some of the buttons on the small toolbar may be slightly different from the large
toolbar button simply because there is no way to successfully reduce the button’s graphic on the large
toolbar. However, the buttons on both toolbars are in the same order and the “tool tips” are the same.