Campbell Scientific OBS500 Smart Turbidity Meter with ClearSensor Technology - Manual (Page 26)

OBS500 Smart Turbidity Meter with ClearSensor™ Technology
Device Configuration allows you to change the configuration of the OBS500.
Select the Settings Editor tab.
FIGURE 7-3. Settings Editor screen
There are three settings that can be changed: SDI-12 address, measurement
mode, and side scatter ratio top. Select the desired values and press the Apply
button.
The SDI-12 address is not used while in analog mode.
7.3 Datalogger/RTU Connection
The OBS500 field cable is typically used to connect to a datalogger or RTU.
The field cable is a molded-cable assembly that terminates with an MCIL wet
pluggable underwater terminator. TABLE 7-3 shows the contact numbers for
the MCIL/MCBH-8 connectors and the electrical functions and wire colors.
NOTE
16