Campbell Scientific PConnectCE Software for Pocket PC PDAs - Manual (Page 23)

PConnectCE for the Pocket PC Handhelds
Terminal
When the Terminal tab is selected, the remote communications command is
sent to the datalogger and it is put into a remote communications state. This
state allows the user to send telecommunications command directly to the
datalogger and is typically used for trouble-shooting.
Keypad for
Entering
Commands
For all dataloggers except the CR1000, CR200, CR800/850, and CR3000, the
datalogger's keyboard/display keypad is depicted on the Terminal window.
The PDA's grafitti pad or keyboard can also be used to enter characters. For
CR1000, CR200, CR800/850, and CR3000 dataloggers, there is no
keyboard/display depicted, so the graffiti pad or keyboard must be used.
For mixed array dataloggers, to return the datalogger to its program execution
state, enter *0. LOG1, LOG2, or LOG12 should be displayed indicating that
the code in program table 1, and/or program table 2, is being run. PakBus
dataloggers do not need to be returned to a logging state.
Terminal mode should be used with caution since it is possible to delete
instructions in the datalogger's program or delete data from the datalogger
while in this mode. Refer to the datalogger's user manual for complete
information on the remote communications mode.
Transfer Program
Switch to the Transfer Program tab to send a new program file to the
datalogger, or to retrieve the program file that is currently running in the
datalogger.
17