Campbell Scientific Sentek TriSCAN® Manual v 1.2a - Manual (Page 16)

TriSCAN Manual Version 1.2a
Copyright © 1991 – 2004 Sentek Pty Ltd All rights reserved Page 9
Getting TriSCAN ready for logging
Probe Assembly and Sensor Addressing
Assembling the Probe
The TriSCAN probe consists of the following components:
•
Handle set with screws
•
Interface board
•
TriSCAN sensors
•
Probe Rod
Assemble the probe following these steps:
1. Insert the probe handle into the top of the probe rod, with the lugs on the handle facing the
connector side of the probe rod.
2. Attach the interface board to the probe rod. Fit the interface board between the lugs on the handle
and the probe rod guides, with the green phoenix connector facing the top of the probe. Plug the
interface into the first available connection on the probe rod.
3. Gently move the interface board along the probe rod so that the holes at the top of the board align
with the holes in the probe rod handle behind. Insert the two small screws into these holes, being
careful not to over-tighten.