Campbell Scientific Sentek TriSCAN® Manual v 1.2a - Manual (Page 17)

TriSCAN Manual Version 1.2a
Copyright © 1991 – 2004 Sentek Pty Ltd All rights reserved Page 10
4. Insert the large screws into the holes in the side of the handle and tighten to hold them in place. Be
careful not to over tighten the screws, as this may damage the interface board.
5. Locate the desired sensor positions on the probe rod, keeping in mind that each probe connection is
spaced 100 mm apart.
6. Position the sensor at the bottom of the probe rod with the ribbon cable facing towards the bottom of
the probe and the connector facing the side of the probe rod that holds the connector plugs.
7. Depress the lever on the bottom side of the sensor, and slide the sensor along the probe rod into
position.
8. Align the lug on the back of the sensor with the notch in the probe rod, and click into position by
pushing the lever outwards with a finger or screwdriver inserted behind the lever.