Campbell Scientific SP50-L/SP90-L Solar Panel - Manual (Page 13)

SP50-L/SP90-L Solar Panel
FIGURE 3-6. Right and left arm brackets are attached to the back of
the solar panel
Orient the solar panel as shown in FIGURE 3-6. Attach the mount to the back
of the solar panel between the right and left brackets already in place as shown
in FIGURE 3-7. Hint: jump to Section 3.3, Orientation, to determine which
holes to use in order to mount the panel at the optimum angle for the site’s
latitude. Use the 5/16-18 x 0.75 hex bolt and nuts along with the matching
lock washers and flat washers. Use a bolt and flat washer from the outside, and
a flat washer, lock washer, and nut on the inside as shown in FIGURE 3-8.
FIGURE 3-7. Attach the mount to the back of the solar panel between
right and left arm brackets
FIGURE 3-8. Use the 5/16 hardware as shown to secure each end of
the mount to the arm brackets.
Bolt
Washer
Washer
Nut
Lock Washer
7