Allied Telesis NETEXTREME II AT-2973SX - Manual (Page 107)

AT-2973SX, AT-2973T, and AT-2973T/4 NetExtreme II Family Adapters Installation and User’s Guide
107
Modifying Advanced Properties
After you have installed the driver software, you can use the following
procedures to verify or change the adapter properties:
 “Updating the Ethernet@ WireSpeed Property” on page 108
 “Updating the Flow Control Property” on page 108
 “Updating the Interrupt Moderation Property” on page 110
 “Updating the Checksum Offload Property” on page 111
 “Updating the Large Send Offload Property” on page 112
 “Updating the Jumbo MTU Property” on page 113
 “Updating the Network Address Property” on page 114
 “Updating the RSS Queues Property” on page 115
 “Updating the Priority & VLAN Property” on page 116
 “Updating the Receive Buffers Property” on page 117
 “Updating the Receive Side Scaling Property” on page 117
 “Updating the Speed & Duplex Mode Property” on page 118
 “Updating the TCP Connection Offload Properties” on page 120
 “Updating the Transmit Buffers Property” on page 121
 “Updating the VLAN ID Property” on page 121
Note
After you upgrade the driver software, the Advanced Properties may
change.
Note
The procedures in the sections listed above may differ slightly if the
“Classic Start Menu” is set on your computer.