Actiontec electronic UP102 - Manual (Page 20)

1
Actontec VoSKY Call Center User Manual
Connecting to a DSL Splitter
If the telephone is connected to the phone line via a wall
mount DSL filter, follow this procedure to connect Call Center:
1. Use the supplied phone cable and insert one end in the “Line”
port of Call Center.
Call Center is connected in Dual-Line mode. Next, go to chapter 4,
“Installing Call Center Software.”
2. Insert the other end of the supplied phone cable in the “Phone”
port of the DSL filter.
3. Get the phone cable from the telephone and insert one end in
the “Phone” port on the rear panel of Call Center.
4. Connect the other end of the phone cable to the telephone. The
components should be connected similarly to the figure below: