AEG MICROMAT_DUO 3534 E - Manual (Page 9)

9
English
Installation and Connection
This appliance complies with the following EC Directives :
EMC Directive 89/336/EEC, Low Voltage Directive 73/23/EEC with amendment
90/683/EEC and the CE marking Directive 93/68/EEC.
Table top model
A gap all around the oven is necessary in
order to ensure perfect ventilation:
Above: 14 cm
Behind: 10 cm
Either side: 5 cm
Connect to a plug socket with protective
earth contact and fused with a 10 A-L
automatic device or a 10 A slow-blowing
fuse.
5 cm
14 cm
10 cm
5 cm
The oven should be set on a work surface at least 85 cm above
floor level. To ensure the stability of the microwave oven, the
front left foot is adjustable (5 positions). Turn it to raise or
lower the appliance. Make sure that nothing obstructs the
ventilation louvres and that air may circulate freely around the
oven.
Built-in model
To install the appliance in a kitchen cabinet, use the appropriate mounting frame.
Note the relevant instructions for installation and connection. When building in to
a high cabinet, you may use the liftdoor. Note the relevant information for
installation and connection given in the operation instructions of the lift door.
Attention!
Never operate the microwave oven with the lift door closed. Such operation would
damage your appliance and invalidate the guarantee.
Connect to a plug socket with protective earth contact and fused with a 10 A-L
automatic device or 10 A slow-blowing fuse. When the oven is installed, there
must be a possibility of disconnecting it from mains with a contact break of at
least 3 mm on all poles.
A suitable size of LS-switch, or a melting or fly-out fuse, are suitable contact-
breakers.
1