Alpine CVA-1003 - Manual (Page 48)

46
-EN
Installation and Connections
Installation
Installing the Monitor
• Location
Before final installation, make sure the display
will not hamper gear shifting when it is opened
and closed in the chosen location.
NOTE
Install at an angle within 30 degrees from horizontal.
1
Slide mounting sleeve from main unit (see
Removal Procedure below). Slide the mounting
sleeve into the dashboard. Install the supplied
bracket to the monitor.
2
Reinforce the monitor with the metal mounting
strap (not supplied). Secure the ground lead of
the unit to a clean metal spot using a screw ( )
already attached to the vehicle’s chassis.
NOTE
For the screw marked , use an appropriate screw for
the chosen mounting
location.
Screws(M4x5)
(Included)
Mounting Bracket
(Included) Dashboard
Mounting Sleeve
(Included)
CVA-1003
3
Slide the CVA-1003 into the dashboard. When
the unit is in place, make sure the locking pins
are fully seated in the down position. This can be
done by pressing firmly in on the unit while
pushing the locking pin down with a small
screwdriver. This ensures that the unit is properly
locked and will not accidentally come out from
the dashboard. Install the Supplied Front Frame.
Removal
1 Use a small screwdriver (or similar tool) to
push the locking pins to the "up" position (see
above drawing). As each pin is unlocked,
gently pull out on the unit to make sure it does
not re-lock before unlocking the second pin.
2 Pull the unit out, keeping it unlocked as you do
so.
<JAPANESE CAR>
Installation using the vehicle's factory brackets.
CVA-1003
Front Frame
(Included)
Bolt Stud
Metal Mounting Strap
Screw
Hex Nut
(M5)
Chassis
Ground Lead
Lock Pin
CVA-1003
Screws
(M4x5)
Mounting Bracket
Ground Lead