Installation and connections – Alpine CVA-1003 User Manual

Page 51

Advertising
background image

49

-EN

Installation and Connections

1 Antenna Receptacle
2 Remote Control Interface Connector

Connect to the remote control interface box.

3 Remote Control Output Lead (White/Brown)

Connect this lead to the remote control input lead.
This lead outputs the controlling signals from the
remote control.

4 Foot Brake Lead

Connect to the vehicle’s foot brake lead or brake lamp
lead.

5 Power Supply Connector
6 System Switch

When connecting an equalizer or divider using Ai-
NET feature, place this switch in the EQ/DIV
position. When no device is connected, leave the
switch in the NORM position.

NOTE

Be sure turn the power off to the unit before changing the
switch position.

7 Illumination Lead (Orange)

This lead may be connected to the vehicle’s
instrument cluster illumination lead. This will allow
the backlighting of the CVA-1003 to dim whenever
the vehicle‘s lights are turned on.

8 Remote Turn-On Lead (Blue/White)

Connect this lead to the remote turn-on lead of your
amplifier or signal processor.

9 Power Antenna Lead (Blue)

Connect this lead to the +B terminal of your power
antenna, if applicable.

! Audio Interrupt In Lead (Pink/Black)
" Parking Brake Lead (Yellow/Blue)

Connect this lead to the power supply side of the
parking brake switch to transmit the parking brake
status signals to the CVA-1003.

# Switched Power Lead (Ignition) (Red)

Connect this lead to an open terminal on the vehicle’s
fuse box or another unused power source which
provides (+) 12V only when the ignition is turned on
or in the accessory position.

$ Battery Lead (Yellow)

Connect this lead to the positive (+) post of the
vehicle’s battery.

% Fuse Holder (15A)
& Ground Lead (Black)

Connect this lead to a good chassis ground on the
vehicle. Make sure the connection is made to bare
metal and is securely fastened using the sheet metal
screw provided.

( Right Front (+) Speaker Output Lead (Gray)
) Right Front (–) Speaker Output Lead (Gray/

Black)

~ Right Rear (–) Speaker Output Lead (Violet/

Black)

+ Right Rear (+) Speaker Output Lead (Violet)
, Left Rear (+) Speaker Output Lead (Green)
- Left Rear (–) Speaker Output Lead (Green/

Black)

. Left Front (–) Speaker Output Lead (White/Black)
/ Left Front (+) Speaker Output Lead (White)
: RGB input Connector

Advertising