AT&T E1833B - Manual (Page 39)

36
ɇŽŽƒŒ‚‡–
There is no dial
tone ƨ ‡‘’Ɛ’—ŠŠ’†ƒ€”ƒ‘“ ƒ‘’‡Œ‘Ɠ
ƨ ”ƒ’†ƒ‚Šƒ‘‘†Œ‚‘ƒ’Š‘ƒ’’†ƒ’ƒŠƒŽ†Œƒ€‘ƒƓ
’
might be out of range.
ƨ †ƒ’ƒŠƒŽ†ŒƒŠ‡Œƒ‚‹‡ †’€ƒ‹Š„“Œ’‡Œ‡Œ Ɠ—‡Œ‘’ŠŠ-
ing a new telephone line cord.
ƨ ‡‘ŒŒƒ’’†ƒ’ƒŠƒŽ†Œƒ€‘ƒ„‹’†ƒ’ƒŠƒŽ†Œƒˆ‰Œ‚
connect a different telephone. If there is no dial tone on the
telephone either, the problem is in your wiring or local serv-
‡ƒƓŒ’’—“ŠŠ’ƒŠƒŽ†Œƒ‹ŽŒ—Ɠ
The telephone
does not ring
when there is an
incoming call ƨ ‰ƒ‘“ƒ’†ƒ‡Œ ƒ‡‘ŒƪŽ ƒǍǎƕǍǏƫƓ
ƨ ‰ƒ‘“ƒ’†ƒ’ƒŠƒŽ†ŒƒŠ‡Œƒ‚Œ‚Ž•ƒ‚Ž’ƒƒ
plugged in properly (page 6).
ƨ †ƒ ‚Šƒ‘‘ †Œ‚‘ƒ’ ‹— €ƒ ’ „ „‹ ’†ƒ ’ƒŠƒŽ†Œƒ
base. Move it closer to the telephone base.
ƨ †ƒƒ‹—€ƒ’‹Œ—ƒ–’ƒŒ‘‡Œ’ƒŠƒŽ†Œƒ‘Œ’†ƒ’ƒŠƒŽ†Œƒ
line to allow all of them to ring simultaneously. Try unplugging
some of them.
ƨ
„’†ƒ’†ƒ’ƒŠƒŽ†Œƒ‘‡Œ—“†‹ƒƒ†”‡Œ ’†ƒ‘‹ƒ
problem, the problem is in the wiring or local service.
Œ’’’†ƒŠŠ’ƒŠƒŽ†Œƒ‹ŽŒ—ƪ† ƒ‘‹—ŽŽŠ—ƫƓ
Troubleshooting
The CHARGE
light is off ƨ ŠƒŒ ’†ƒ ‹ƒ’ŠŠ‡ † ‡Œ  Œ’’‘ Œ ’†ƒ ‚Šƒ‘‘
handsets and telephone base each month using a pencil
eraser or a dry non-abrasive fabric.
ƨ ‰ƒ ‘“ƒ ’†ƒ Ž•ƒ ‚Ž’ƒ Œ‚ ’ƒŠƒŽ†Œƒ Š‡Œƒ ‚‘
are plugged in correctly and securely.
ƨ ŒŽŠ“  ’†ƒ Ž•ƒ ‚Ž’ƒƓ ‡’ „ ǍǑ ‘ƒŒ‚‘ €ƒ„ƒ
plugging it back in. Allow up to one minute for the cord-
less handset and telephone base to reset.
ƨ †ƒ ’ƒŠƒŽ†Œƒ ‹‡ †’ €ƒ ‹Š„“Œ’‡Œ‡Œ Ɠ Šƒ‘ƒ ƒ„ƒ ’
the Limited warranty section of this user’s manual for
further instruction.
ƨ
’ ‹— €ƒ Œƒƒ‘‘— ’ Ž“†‘ƒ  Œƒ• €’’ƒ—Ɠ Šƒ‘ƒ
refer to the Batteries section of this user’s manual.
ƨ †ƒ ’ƒŠƒŽ†Œƒ ‹‡ †’ €ƒ ‹Š„“Œ’‡Œ‡Œ Ɠ Šƒ‘ƒ ƒ„ƒ ’
the Limited warranty section of this user’s manual for
further instruction.