Samsung SC-M105S-XAC - Manual (Page 101)

ENGLISH
◆
[ ▲ /▼ ]
◆
✤
✤
✤
✤
✤
✤ ‘USB-D07 Capture Device hasn’t
passed Windows Logo testing’
Setting the CAM : Using USB Mode
101 101
Trnsferring Files from the CAM to your computer
1. Connect the CAM to the PC with
the USB cable.
2. Slide [Mode Selector] down to
turn on the CAM.
◆ USB menu screen appears
automatically.
3. Slide the [ ▲/▼] switch to select
<USB 2.0 MassStorage> or <USB
1.1 MassStorage> and press the
[OK] button.
◆ Your PC recognizes the USB
device automatically. You must install the
USB Driver manually on Windows 98SE
operating system.
4. Disconnect the USB cable if you finish
transferring.
Notes
✤ Select <USB 1.1 MassStorage> when <USB 2.0
MassStorage> does not work depending on your PC environment.
✤ If you disconnect the USB cable from the PC or the CAM during the
data transfer, the data transfer will stop and the data may be damaged.
✤ If you connect the USB cable to a PC using a USB HUB or with
other device at the same time, it might cause conflict and may not
work properly. If this occurs, remove all other devices and try the
connection again.
✤ Install the Windows 98SE Driver on Windows 98SE operating
system using supplied CD. Refer to page 113 for further details.
✤ It takes about 30 minutes if you download or upload a 1GB file via
a USB cable.
✤ When connecting the CAM to your PC, if the message ‘USB-D07
Capture Device hasn’t passed Windows Logo testing’ appears, do
not be concerned, it is OK to proceed with file transfer.
Back
USB Mode
PC-Cam
PictBridge
USB 2.0 MassStorage
USB 1.1 MassStorage