ArtDio IPS 1000 - Manual (Page 17)

IPS 1000 Series VoIP Gateway
17
9.2.2. DHCP Mode
1. Connect the IPS unit to a suitable Power source.
2. Connect a traditional phone set to the “FXS” connector located on the rear panel.
3. When the CPU/ACT light is on, pick up the phone to hear the dialing tone.
4. ##0000 ; you should hear three short tones.
5. 011# ; the digit “1” is used to enable “DHCP” IP mode.
6. 15123# ; “123” is the web management password.
7. 981# ; Warm-restarts.
8. Hang up the phone. The system should now restart.
You can also use console to configure IP address. But phone number can’t be configured by
console.(Only for 4 ports gateway)
SIP-RG>enable
SIP-RG#configure
Enter configuration commands, one per line. End with CNTL/Z
SIP-RG(config)#ip state dhcp
SIP-RG(config)#exit
SIP-RG#restart
This command resets the system. System will restart operation code agent.
Reset system, [Y]es or [N]o? Yes
9.2.3. PPPoE Mode
If your network environment is using PPPoE, you need to prepare the information as specified in section
8. Information required before Installation.
The following table shows an example.
PPPoE Account [email protected]
PPPoE Password 123ab
Web management password 123
There are three ways to configure user name and password of PPPoE
1. Use phone set to configure:
You can configure the user name and password by using phone set. The command ‘09’ is used for
username and ‘10’ is for password of PPPoE. Since the user name and password use characters and