ArtDio IPS 1000 User Manual

Page 18

Advertising
background image

IPS 1000 Series VoIP Gateway

18

digits are accepted by phoneset only, you need a mapping between characters and digits. You can find

them at section 14.4 Mapping table of characters used in PPPoE.

Example user name:[email protected],Password:123ab,The procedure is below

1. Connect the phone to IPS

2. When CPU/ACT is light, pick up the phone

and press

3. ##0000

;You will hear 3 short tones.

4. 0938333732314068696*465742*46*46574# ;Set user name:[email protected]

5. 103132336162#

;Set password is 123ab

6. 981#

;Save and restart.

2. Use Console to configure (Only for 4/8/16 ports Gateway)

SIP-RG>enable

SIP-RG#configure

Enter configuration commands, one per line. End with CNTL/Z

SIP-RG(config)#pppoe username [email protected]

SIP-RG(config)#pppoe password 123ab

SIP-RG(config)#exit

SIP-RG#restart

This command resets the system. System will restart operation code agent.

Reset system, [Y]es or [N]o? Yes

3. Use WEB Interface to configure:

You can configure the user name and password by using WEB interface. Follow the steps to finish

configuration.

Step 1: Using a traditional phone set to configure the web management password and phone number

You will need to use a web browser to perform the PPPoE settings through the IPS unit’s web based

management interface. To enter the web based management interface you must have a previously

configured password. Follow the next procedure to setup your password and phone number.

1. Connect the IPS unit to a suitable Power source.

2. Connect a traditional phone set to the “Phone” connector located on the rear panel.

3. When the CPU/ACT light is on, pick up the phone. You should hear the dialing tone.

4. ##0000

; you should hear three short tones.

5. 15123

; “123” is the web management password.

6. 010#

; “0” is to enable “manual” IP mode.

Advertising