Samsung WF457ARGSGR-AA - Manual (Page 21)

Installing your washer _21
01
INS
TALLING Y
OUR W
ASHER
STEP 3
Connecting the water and the drain
Connecting the water supply hose
Do not connect multiple water supply hoses. This may result in a water leakage and electric
shock due to the water leakage. If the hose is too short, replace the hose with a longer,
high pressure hose.
1. Connect one end of the COLD water supply hose to the
COLD water supply intake at the back of the washer.
2. Tighten part (A) by hand until it is snug, then make two-
thirds of a turn with a wrench.
3. On the other end of the hose, check for one rubber washer
per hose and install each water supply hose to the faucet.
Make sure the hose with the printed word HOT is
attached to the HOT faucet.
4. Tighten part (A) by hand until it is snug, then make two-
thirds of a turn with a wrench.
For the correct water use, connect both the HOT
and COLD water faucets. If either or both are not
connected, an “nF” (no fill) error can occur.
After you have connected the water supply hose to
the faucet, ensure that it is connected correctly by
pulling the water supply hose downwards.
Check if the water supply hose is not twisted or bent.
If the hose is twisted or bent, there is a danger of a
water leakage and electric shock due to the water
leakage.
5. Turn on the HOT and COLD water supply and check all
connections at the water intake and the faucet for leaks.
Cold hot
Rubber
Washer
A
CAUTION
WARNING
WF457ARG-03153A-07_EN.indd 21 2013-12-13 10:40:19