Samsung SGH-T469DAATMB - Manual (Page 115)

Organizer 112
Speak clearly when giving your command. There is no need for you to speak slowly or with added emphasis. The
voice recognition software has been optimized to understand your speech in its natural form. If it does not
recognize your command after a few seconds, a voice prompt asks you to repeat the command. If it does not
recognize your command again, the following message displays “Sorry, no match found,” and voice recognition
turns off.
Important!: You must end your current Voice Commands call before you can make another call.
Voice Recognition Tips
• Wait for the tone before you speak.
• Speak clearly and at a normal volume.
• There is no need to use paused speech. The voice recognition software has been trained to recognize natural speech, and
performs best when you speak naturally.
• In very noise environments, it may be helpful to use the supplied earset or optional Bluetooth headsets.
Contacts List Voice Activation
On startup Nuance reads your Contacts list and voice-activates all the names.
When you have add or change contacts, Nuance automatically reloads and voice-activates the list when you add or
modify a contact.
Name Dialing
To use Name Dial, you need contacts stored in your Phonebook. For more information, refer to “Using Contacts
List” on page 62.
To access Voice recognition:
1. In Idle mode, press Menu ➔ Organizer ➔ Voice recognition.
2. Say “Call” followed by the first and last name of the contact that you want to dial.
The name that you said is repeated through the earpiece and your phone dials the number.
3. If Nuance is not sure of the name that you said, “Try Again?” displays on the screen.
4. You’re asked to confirm the correct name as Nuance displays the results. Say “Yes” or “No” to confirm or
reject the number when prompted.
t469.book Page 112 Friday, July 10, 2009 11:05 AM