Samsung NP-X22-K01-SEA - Manual (Page 76)

7
5
Click General tab and select a LAN driver from
Connect using:. Select Internet Protocol(TCP/IP)
and click
Properties.
Note
The displayed LAN driver may vary depending on
the LAN device type.
Click
Install to add a network component as shown
in the figure below: You can add a client, a service,
or a protocol.
6
Configure IP settings.
Select Obtain an IP address automatically when
using DHCP. If you use a static IP, select Use the
following IP address and enter the values.
Note
If the IP of your computer is not automatically
assigned, contact the network administrator.
7
If all settings are made, click OK. Now the network
configuration is finished.