Samsung DMR77LHW-XAC - Manual (Page 18)

1_ installing the dishwasher
STep 11 cOMPleTING The INSTAllATION
1. Open the door and remove all foam, paper packaging and unnecessary parts.
. Turn on the circuit breaker turned off before beginning the installation.
. Open the water supply valve to supply water to the dishwasher.
. Turn on the dishwasher, and select and run a cycle.
Check whether the power turns on correctly or whether there is any water leakage while the
dishwasher is operating. If no errors occur while it is operating, turn off the dishwasher and
proceed with the following. If an error has occurred, turn off the dishwasher, close the water
supply valve and refer to the user manual or contact a service center 1-800-SAMSUNG
(726-7864).
Make sure to check water leakage from both ends of water supply line and drain hose
connector.
. Check that the kick plate gasket is on the bottom of the kick plate where is placed on the
cushion front. To install the kick plate, refer to the figure below.
installing the dishwasher
CAUTION