Samsung DMR77LHW-XAC - Manual (Page 9)

installing the dishwasher _
02 I
NST
A
ll
ING
T
he d
IS
h
W
AS
her
STep  WATer SUPPly reqUIreMeNTS
1. The dishwasher can be connected to either the hot or the cold water supply. If the
temperature of the water supplied to the dishwasher is below 149 ˚F (65 ˚C), connect it to the
hot water supply. If it is higher than 149 ˚F (65 ˚C), connect it to the cold water supply.
. Ensure that the water supply valve is turned off before connecting the water supply line to the
dishwasher.
. Seal the water supply line connections using teflon tape or sealing compound to stop any
water leakage.
. The water supply line should be placed in the channels at the base of the dishwasher as
shown in Figure 2. Do not place the dishwasher on the water supply line.
. The drain hose connected to the dishwasher must be run through the hole in the side wall so
it can be connected to the drain outlet of the sink. Ensure that there is nothing on the drain
hose and be careful not to tear it during the installation process.
<figure >
Water supply
line
power cable
½~½ in.
(10~10 mm)