Samsung WF231ANW-XAA - Manual (Page 31)

troubleshooting and information codes _31
A fault is detected in the water
level sensor. Call for service
Jammed Key. Call for service
Motor speed sensor problem. Restart the cycle.
If the code reappears, call for service.
Temperature sensor problem. Restart the cycle.
If the code reappears, call for service.
High current detected. Restart the cycle.
If the code reappears, call for service.
High/Low voltage detected. Restart the cycle.
If the code reappears, call for service.
Too many suds are detected
during the washing session.
The unit is put on hold until the
suds are reduced. Then, the unit
will go back to the operation.
When it fi nishes washing, End and
Sd codes will blink in turn.
To prevent, reduce the amount of detergent.
For any codes not listed above, call 1–800–726–7864 (1–800–SAMSUNG)
04 TROUBLESHOOTING
WF231ANW-02832D_EN.indd Sec10:31 WF231ANW-02832D_EN.indd Sec10:31 2011-04-18 10:38:32 2011-04-18 10:38:32