Samsung SC-D5000-XAC - Manual (Page 34)

ENGLISH
Preparation
34 34
Controlling Sound from the Speaker
Adjusting the LCD during PLAY
✤ You can adjust the LCD during playback.
✤ The adjustment method is the same as is used while in
CAMERA mode. (See page 32)
The Speaker only works in PLAYER mode.
■ When you use the LCD screen for playback,
you can hear the recorded sound from the built-in
Speaker.
-
Follow the instructions below to decrease or
mute speaker volume in PLAYER mode.
- Take the following steps to lower the volume or
mute the sound while playing a tape
on the camcorder.
1. Set the device to CAMCORDER and set the Power
Switch to PLAYER mode.
2. Press (PLAY/STILL) to play the tape.
3. Once the tape is in play and you hear sound, use
the MENU DIAL to adjust the volume.
■ A Volume Level display will appear on the LCD.
Levels may be adjusted from anywhere
between 0 to 19. You will not hear any sound
when the volume is set on 0.
■ If you close the LCD while playing, you will not
hear sound from the speaker.
Notes
■ When the cable is connected to the A/V jack, you cannot hear
sound from the speaker and cannot adjust the volume.
■ You can hear sound from the speaker by removing the connected
cable from the A/V jack
✤
✤
■
■
■
■
■
0 : 2 3 : 4 7
5 5 min
1 2 : 0 0 AM
O C T . 1 0 . 2 0 0 3
VOL. [ 1 1 ]
<3-2>
FADE
S.SHOW
BLC
REV FWD
TAPE
MEMORY
PLAY
REC
OFF