Altec Lansing A7 - Manual (Page 6)

4 ■ A 7 O w n e r ’ s M a n u a l
a s s e m b l y
IMPORTANT: FINISH ASSEMBLY BEFORE CONNECTING TO AMPLIFIER
For protection, this A7 loudspeaker is shipped with the horn assembly fixed inside
the cabinet. For optimum sound quality, follow the assembly steps below for
repositioning the horn assembly on top of the loudspeaker cabinet.
STEP 1: Support the horn assembly during removal. Using a 5/32" allen
wrench, gently remove the allen screws, and washers holding the
horn assembly inside the cabinet. Keep track of the provided lock
nuts, washers and screws for later use.
STEP 2: Attach the front and rear support brackets to the horn utilizing the
allen screws, washers and lock nuts provided. This will require the
5/32" allen wrench and a 7/16" wrench or socket.
STEP 3: Position the horn/bracket assembly on top of the cabinet over the
pre-drilled holes. Using a 5/32" allen wrench, reattach the horn
assembly to the cabinet using the same allen screws,.
STEP 4: Attach the Blue and Yellow wires extending from the top of the
back panel to the positive and negative terminals of the Model 902
compression driver. Yellow is connected to the Positive terminal and
Blue to the Negative terminal.
WIRING
IMPORTANT: CHECK YOUR AMPLIFIER'S IMPEDANCE AND POWER
SPECIFICATIONS
This A7 loudspeaker has an 8 Ohm (_) input impedance and is designed to handle
continuous input power levels of up to 125 Watts RMS.
Do not connect this loudspeaker to amplifier speaker terminals which are rated at
less than 8 Ohms (_); significant damage to the loudspeaker could result.
Do not connect this loudspeaker to an amplifier rated at more than 125 Watts
RMS per channel; significant damage to the loudspeaker could result.