Ampeg SJ-12T - Manual (Page 6)

6
(Reverb cables:
do not disturb) (Reverb cables:
do not disturb) 13 14 15 10 11 12
10. Power cord connects the amplifier
to a suitable source of A.C. voltage. This
is a grounded, three-wire cord and must
be connected to a properly grounded
outlet.
DO NOT attempt to defeat the
ground connection of the power cord!
If your amp was purchased outside of
the United States, see the sticker next to
the A.C. connector for its power ratings.
Follow the above guidelines.
11,12. Power Tubes: 6L6 (2)
13. Power Amp Phase Splitter Tube:
12AX7A / 7025 (1)
14. Preamp Tube: 12AX7A / 7025 (1)
Replace tubes ONLY with same types!
Refer to pages 7 through 10 for impor-
tant information about tubes and tube
products.
15: Footswitch Jack is located up inside
the amplifier, just past the cabinet’s cov-
ered back panel. Connect the supplied
footswitch here for remote control of the
Reverb and Tremolo on/off.
The Rear Panel: