Avalon Stoves Arbor PS - Manual (Page 11)

Installation
(For Qualified Installers Only)
1 1
© Travis Industries
4070806
1 0 0 - 0 1 1 9 1 _ 0 0 0
Mobile Home Requirements
• Outside air is required (used for
combustion) - see the directions
below.
• The heater must be bolted to the
floor (Some states do not require
this; check with your local building
department). See the illustration
to the right.
• The heater must be grounded to
the steel chassis of the mobile
home (Some states do not require
this; check with your local building
department).
WARNING: DO NOT INSTALL IN
SLEEPING ROOM.
CAUTION: THE STRUCTURAL
INTEGRITY OF THE
MANUFACTURED HOME
FLOOR, WALL, AND
CEILING/ROOF MUST BE
MAINTAINED.
The leveling bolts in the legs may be used
in conjunction with the included clips (sku
210-03924) to secure the stove to the floor.
Outside Air (used for combustion)
• Must not be drawn from an enclosed space (garage, unventilated crawl space).
HINT: Travis Industries strongly suggests outside air for all residential installations, especially for
those that are energy efficient, air-tight homes.
• Must not be over 15' long.
• Must be made with 3" diameter or larger metal or aluminum duct with a metal screen attached to
the end to keep out rodents (P.V.C. or other combustible materials may not be used). We
recommend the Travis Industries Outside Air Kit (part # 99200136).
• Must not terminate above or within 1' of the chimney termination.
• Must have a rain cap or down-turned elbow to prevent water from entering.
• Must be located so that it will not become plugged by snow or other material.
3” Air Duct
(99200136 includes 4’ length)
A screen is required to prevent
rodents from entering.
Outside air entrance must be placed so it
does not become blocked by snow.
Air may be drawn from a ventilated crawl space.
Botttom of Stove
Use a hose clamp to secure the
aluminum air duct to the air inlet
flange on the stove.
Air Duct (3” Dia.)